You are buying an assembled and tested Amiga Floppy Drive adapter for internal or external use.

This adapter can make standard PC floppy drives work on an Amiga computer (as DD drives only!).
It will also work with regular Amiga drives and floppy drive emulators such as GoTek, HxC or Raspberry Pi Drive (one drive only!).

This device will work with any classic Amiga computer (1000, 500, 600, 1200, 2000, 3000, 4000).
It can be connected to the internal or external floppy drive port.

When connected externally, the Amiga's disk drive port's power connection can be used, but it might be insufficient for stable operation.
Therefore, a standard power connection is also recommended, which can be daisy-chained to the floppy drive.
As standard, the adapter will come with two 4-pin power connectors, optionally one can bbe replaced with a power cable.

Most games and demos will work fine.
No special software or driver is required.

To make the adapter as compatible as possible, several things can be configured via jumper switches:
- READY signal for PC or Amiga drives
- DISK CHANGE signal for PC or Amiga drives
- hardware selected drive ID (DS0, DS1 or DS2).
   Standard Amiga drives are usually set to DS0, PC drives are usually set to DS1, some older drives might be set to DS2.
- Amiga floppy drive ID (DF0, DF1, DF2 or DF3)
   On external connections DF0 is not available.
   Standard internal connections allow for DF0 or DF1 only. Additional signals for DF2 or DF3 may have to be connected.

For external connections an adjusted DB25 connector with 3D printed frame was fitted which fits the Amiga's DB23 port.
All required 34-conductor flat ribbon cables (optionally included) should be one-to-one, no twists required.